DTS10 HAGIE SELF PROPELLED SPRAYER

6.7-L (408.9-cu in.) Cummins® QSB engine

Final Tier 4 (FT4) diesel engine

The Hagie DTS10 is powered by a 6.7-L (408.9-cu in.) Cummins QSB diesel engine providing 165-kW (225-hp) using an emissions-compliant Final Tier 4 (FT4) configuration. This 6.7-L (408.9-cu in.) engine is electronic with an air-to-air cooler and turbocharger.

The FT4 engine requires ultra-low sulfur diesel (ULSD).

Engine location

Engine location

The rear-mounted engine keeps constant weight to offset the spray boom and leaves space in the center of machine for the varying weight of fuel and rinse tanks. This allows for better coolant airflow and reduction of cab noise.

Engine exhaust

Engine exhaust stack

The engine exhaust is located at the rear of the machine. This helps to reduce interior cab and noise vibration.

Cummins is a trademark of Cummins, Inc. Hagie is a trademark of Hagie Manufacturing Company, LLC and similar to John Deere branded equipment, Deere will also support Hagie equipment.

Front console

Front console steering

Front console telescope

Front console tilt

Front console foot controls

Side console

Overhead monitors and controls

NORAC is a trademark of NORAC Systems International, Inc. iPod is a trademark of Apple, Inc. Bluetooth is a trademark of Bluetooth SIG, Inc.

Solution tank

Solution tank

Solution tank drain grade

Two 1892-L (500-gal.) polyethylene tanks are mounted on tank cradles on each side of the machine. The solution tank design allows the sump to drain on a 30 percent grade and is equipped with a spinball rinse system. A mechanical sight gauge is located on top of each solution tank to visually check the solution level at all times.

Solution pump

Solution pump

The Hypro® 9306C-HM1C solution pump (located beneath the center of the machine) is a centrifugal-type hydraulically driven pump that is controlled by the solution pump control valve and the spray system console. It comes with silicon-carbide seals.

The solution pump draws solution out of the tank at the rate determined during calibration. It dispenses solution through the many valves and hoses that make up the spray system and also dispenses fluids through the agitation and rinse systems.

Solution pump switch

Solution pump switch

Solution pump indicator

The solution pump switch is located on the side console and is used to turn the solution pump on and off.

NOTE: When the solution pump is on, a solution pump indicator (located on the machine display home page - field mode) will illuminate.

Hypro is a trademark of Pentair Flow Technologies, LLC.

Wet boom

The spray booms are controlled by an electrohydraulic system. This system consists of operator-manipulated switches (located on the side console and the hydrostatic drive control handle) and hydraulic cylinders (attached to the booms), which provide lift, level, and horizontal extension.

Hydraulically folding the extensions of an 18.3- or 24.4-m (60- or 80-ft) or 18.3- or 27.4-m (60- or 90-ft) spray boom and shutting off the outer sections essentially turns it into an 18.3-m (60-ft) spray boom. The wet boom connections feature with ARAG® EasyFit fittings with an o-ring seal and are 13-mm (0.5-in.) schedule 5 pipe-fed from one end with a 25-mm (1-in.) hose.

Boom connections

Boom configurations

ARAG is a trademark of ARAG S.r.l.

Chassis mainframe

Horizontal cross-through axle tube

The DTS10 Sprayer mainframe design features horizontal cross-through axle tubes, as well as boom and platform mounts on weldment.

• 360.7-cm (142-in.) mainframe width
• 182.9-cm (72-in.) ground clearance